How much fuel loss is normal at a fuel station?
For owners, station managers, accountants · By the Petro team · Last reviewed
The short answer
A small difference between the dip and the book stock every day is normal, and over a week the small shortages and small gains should roughly cancel out. There is no single published tolerance that fits every Sri Lankan station, so the useful figure is your own: the loss each tank shows over a month as a percentage of the litres it sold. Measure that baseline for two or three months with careful dips, then treat anything clearly above it, or any steady one-way drift, as a problem to investigate.
Is there an official allowed loss figure?
Station owners often hear a percentage quoted as the normal or allowed loss, but these figures usually come from habit, from another country or from a supplier's internal practice. We have not found a published Sri Lankan figure that sets an acceptable loss for a retail fuel station's tanks. If your dealer agreement with CPC or Lanka IOC mentions a handling or evaporation allowance, that agreement is what applies to you, so read it or ask your oil company's area officer.
Even where a figure exists, it is a ceiling for disputes, not a target. A station that runs well usually loses far less than any allowance, and a station that sits right at the allowance every month is often hiding a fixable problem inside it.
What does a healthy tank look like day to day?
Take the daily difference for each tank: dip minus book. On a healthy tank the figure moves around zero. Some days are a few litres short, some a few litres over, depending on who read the stick, the temperature and how long the fuel had to settle. What you should not see is the same sign day after day.
- Scattered small shortages and gains that roughly cancel over a week: normal reading noise.
- Small shortages almost every day: a steady cause, such as a meter that has drifted, a slow leak, a calibration chart that is slightly off, or test litres not really poured back.
- One large difference on one day: usually a paperwork event, such as a delivery on the wrong day or tank, a mistyped reading, or a dip taken while fuel was still settling.
- Steady gains: also a problem. Fuel does not appear from nowhere, so a delivery, a meter reading or a chart is usually recorded short.
How do I set my own baseline?
Your baseline is what a well-run month looks like for each of your tanks, measured as a percentage of sales so that busy and quiet months can be compared.
- Fix your routine first: dip every tank at the same time each day, after the pumps on it have been idle for a few minutes, by the same trained person where possible, and dip before and after every delivery.
- Check the paperwork daily for at least two or three months: every delivery against its note and its before and after dips, every meter reading against the previous shift, and every test litre.
- At the end of each month, add up each tank's daily differences and divide by the litres that tank sold. That percentage is the month's result for the tank.
- Once you have two or three clean months, the typical result for each tank is its baseline. Petrol and diesel tanks often settle at different figures, and so can a shaded tank and one in full sun.
When is a loss too much?
Once you have a baseline, set two simple triggers for each tank and look at them every week rather than at month end.
- A level trigger: the running month-to-date loss is clearly above the baseline, for example more than double it, at the same point in the month.
- A pattern trigger: the tank has been short on most days for a week, even if each day is small.
Either trigger is a reason to go through the paperwork for that tank, then the physical checks: a careful re-dip, a check for water, a test of the meters on the tank's pumps, and if it persists, a leak test of the tank and lines.
Why should I measure loss per tank and not per station?
A station total mixes tanks together, so a gain in one tank can hide a loss in another. Two tanks of the same fuel are a common case: a delivery entered into the wrong tank shows as a gain in one and a loss in the other, and the station total looks fine. Measure each tank against the pumps that actually draw from it, and only then add the tanks up.
Frequently asked questions
- Is a loss of about half a percent normal?
- It depends on your tanks, your dipping and your climate, which is why your own baseline matters more than any quoted figure. Many well-run tanks lose noticeably less than that. If your figure is that high, check the paperwork and the meters before accepting it as normal.
- Should the baseline be the same for petrol and diesel?
- Not necessarily. Petrol is more volatile than diesel and tanks differ in size, age and exposure to sun, so set a baseline per tank and compare each tank only with itself.
- Can I compare my loss with another station's?
- Only roughly. Another station's figure depends on their tanks, their dipping and how honestly they record it. Your own history, measured the same way every month, is a far better guide.
- Who should look at the figures?
- The manager should see the daily difference per tank every morning, and the owner should see the weekly running total. A loss noticed the next day can still be traced; one noticed at month end usually cannot.
How Petro handles this
In Petro the daily Fuel Stock Balance shows each tank's book reading, dip reading and dip difference, marked as a shortage or a gain, with totals for each fuel. Each tank also has a Dip Reading Overview chart of dip against book over time, so a steady one-way drift is easy to see, and the Stock Reconciliation Report lists the gains and losses found by dips in litres and value.
See fuel operations in PetroThis guide is general information for Sri Lankan fuel stations, written by the Petro team. Figures in examples are made up. For a decision about your own tax or legal position, check with your accountant or the authority named in the sources.
