Why don't my dip readings match my pump meter sales?
For owners, station managers · By the Petro team · Last reviewed
The short answer
Some difference between the dip and the book stock is normal every day, because a dip stick is read by eye and fuel expands and contracts with temperature. A difference that keeps growing in one direction, or that suddenly jumps, has a cause you can find: a misread or wrongly converted dip, a delivery entered wrongly or short, testing litres not put back, a meter that has drifted, or fuel leaving the tank some other way. Work through those in order, tank by tank, starting with the paperwork.
What are the two numbers, exactly?
The book stock is what should be in the tank on paper: yesterday's closing stock, plus the deliveries received into that tank, less the litres the pump meters say were sold from it. Litres pumped into a measure for testing and poured back are not sales, so they go back into the book stock.
The dip is what is actually in the tank: the depth of fuel read off a dip stick (or a tank gauge), converted to litres with the tank's calibration chart. The difference between the two, dip minus book, is the day's gain or loss for that tank.
How much difference is normal?
There is no single figure that fits every station: it depends on the tank size, how the dip is taken, the fuel and the weather. What matters more than any one day is the pattern. A healthy tank shows small shortages and small gains that roughly cancel out over a week. A tank that is short day after day, even by a small amount, is losing fuel or mis-recording it, and the losses add up over a month.
Keep a running total of the daily difference for each tank, and compare it with the litres sold. Watch for the cumulative figure drifting steadily in one direction rather than reacting to a single bad day.
What causes the dip and the meters to disagree?
- The dip itself. The stick not held vertical, read at an angle, read too soon after a delivery while the fuel is still settling, or a different person reading it differently each day. A small misreading near the middle of a large tank can be many litres.
- The calibration chart. The wrong chart for the tank, an old chart after the tank was moved or re-laid, or a mistake converting depth to litres.
- Deliveries. A delivery entered against the wrong tank or the wrong day, entered at the invoiced quantity when less was actually received, or not entered at all.
- Meter readings and testing. A closing reading typed wrongly, a pump assigned to the wrong tank, or test litres recorded as poured back when they were not (or the reverse).
- Temperature. Fuel expands as it warms. Fuel delivered cool in the early morning and dipped in the afternoon heat can show a small gain, and the reverse can show a small loss.
- Physical loss. A leaking tank or line, water getting into the tank and being counted as fuel, a meter that has drifted and dispenses more than it records, or theft.
How do I find the cause?
Start with the causes that cost nothing to check and are the most common: the paperwork. Only move to the physical checks once the records are right.
- Re-dip the tank yourself, with the pumps on that tank idle for a few minutes, and convert it again from the chart.
- Check every delivery into that tank over the period against the delivery note and the dip taken before and after it was unloaded.
- Check each pump's opening and closing meter readings against the previous shift's closing readings, and check which tank each pump draws from.
- Check the test litres recorded against what the pumpers actually did.
- If the shortage is still there, use water-finding paste on the dip stick to check for water at the bottom of the tank, and ask your supplier or a licensed technician to check the meters on that tank's pumps.
- If the shortage continues with the paperwork right and the meters accurate, treat it as a possible leak and have the tank and lines tested. A leaking tank is a safety and environmental risk, not only a stock loss.
What should I change so it is caught sooner?
- Dip every tank at the same time every day, after the pumps on it have been idle for a few minutes, and have the same trained person do it where you can.
- Dip before and after every delivery, and record both dips with the delivery.
- Set dip against book tank by tank, every day, not once a month. A difference found the next morning can still be traced; a difference found at month end usually cannot.
- Keep the running total per tank and look at the trend weekly.
Frequently asked questions
- Should I compare dips per tank or per fuel?
- Per tank. Two tanks of the same fuel can hide each other's problems: a gain in one and a loss in the other add up to nothing in a total for the fuel. Compare each tank against the pumps that draw from it.
- Why does the tank show a gain after a hot day?
- Fuel expands as it warms, so the same mass of fuel takes up more litres. A small gain after fuel delivered cool is dipped in the heat is expected. A large or repeated gain usually means a delivery or a meter reading was recorded short.
- Is an electronic tank gauge more accurate than a dip stick?
- A well-maintained gauge removes the person-to-person differences in reading a stick, which is the biggest source of day-to-day noise. It still needs a correct calibration chart and occasional checks against a manual dip.
How Petro handles this
In Petro the station enters a dip reading per tank and Petro fills in the book stock beside it, from the opening stock, the deliveries received and the litres the pumps sold, with tested litres put back. Each reading shows the difference in litres, each tank has a chart of dip against book over time, and the daily Fuel Stock Balance marks every tank's difference as a shortage or a gain.
See fuel operations in PetroThis guide is general information for Sri Lankan fuel stations, written by the Petro team. Figures in examples are made up. For a decision about your own tax or legal position, check with your accountant or the authority named in the sources.
