What should I do if a pump dispenses short or over?
For owners, station managers · By the Petro team · Last reviewed
The short answer
Test the pump with a clean, certified measure, at a normal filling speed, several times, and compare the litres in the measure with the litres on the meter. A pump that gives less than it shows short-changes customers and should be taken out of use until it is corrected; one that gives more than it shows loses you fuel every day. Do not open or adjust a sealed meter yourself: call your oil company or the dispenser's authorised technician, and ask them about any official reverification needed afterwards.
What do short and over mean?
- Dispensing short: the customer gets fewer litres than the meter shows. The station's stock looks fine or even shows a gain, but customers pay for fuel they did not receive, which is unfair to them and puts the station's name at risk.
- Dispensing over: the customer gets more litres than the meter shows. The meters record fewer sales than the fuel that left the tank, so the tank shows a steady shortage that no paperwork check explains.
Both are worth catching early. A short pump is a trust and compliance problem; an over pump is a quiet daily loss.
How do I test a pump properly?
- Use a clean, dry certified measure of a known size, such as a five or ten litre measure, standing on a level surface.
- Wet the measure first by filling and emptying it once, so the test is not affected by fuel clinging to a dry inside.
- Fill the measure at a normal filling speed until the meter shows exactly the measure's volume.
- Read the measure's scale at eye level. Note how far above or below the mark the fuel stands.
- Repeat at least two or three times, and once at a slower speed. Note each result.
- Pour the test fuel back into the tank the pump draws from, and record the tested litres so they go back into the book stock.
What should I do if a pump is out?
- If the pump dispenses short, stop using it until it is corrected. Put up a notice and use the other nozzles.
- If it dispenses over, you may keep it running while you arrange the repair, but note the error so the tank's figures can be read correctly in the meantime.
- Do not break a seal or adjust the meter yourself. Call your oil company's area officer or the dispenser's authorised service technician.
- Ask them whether the pump needs to be officially re-checked and sealed after the repair, and keep the paperwork they give you.
- After the repair, test the pump again yourself and record the result.
- If the meter display was changed or reset during the repair, record the new reading so the next shift starts from the right figure.
Do my own tests replace the official checks?
No. Your daily tests are a station control; they do not replace any official verification of measuring instruments used in trade. Ask your oil company's area officer which official checks apply to your dispensers, how often, and who must re-check a pump after a repair, and keep every certificate and seal record together where an inspector or your oil company can see them.
How often should I test the pumps myself?
- A quick test of every nozzle at the start of each day or each shift is common practice, and it also shows customers that you care about accuracy.
- A full test, several fills at different speeds, whenever a tank shows a steady shortage or gain, after any repair, and after a power or meter fault.
- Keep a simple log of every test: date, nozzle, measure size, result, and whether the fuel was poured back.
Frequently asked questions
- What should I do if a customer says a pump gave short?
- Thank them, and test that nozzle with a certified measure while they watch if they wish. If the pump is accurate, show them the result. If it is not, put things right with the customer, take the nozzle out of use and call your technician. Either way, record the complaint and the test result.
- Is a small error acceptable?
- The error allowed for a fuel dispenser is very small. Rather than relying on a figure you heard, treat any error you can see in a certified measure as worth reporting, and ask your oil company what the current limit is.
- Do test litres count as sales?
- No. Test litres poured back into the tank they came from are not sales, and must be recorded as tested so they go back into the book stock. If they are not really poured back, the tank will show a shortage.
- Can a meter drift over time?
- Yes. Wear in the meter, a dirty filter or changes in flow can shift accuracy gradually. That is why regular testing matters even on a pump that was accurate when it was installed.
How Petro handles this
In Petro the tested litres are entered on each pump line at shift close and go back into the tank, so book stock is not reduced by testing. After a meter reset or repair, a station manager can correct the pump's current reading by hand, and the Fuel Day Final Report V2 shows every pump's in reading, out reading and litres for the day.
See fuel operations in PetroThis guide is general information for Sri Lankan fuel stations, written by the Petro team. Figures in examples are made up. For a decision about your own tax or legal position, check with your accountant or the authority named in the sources.
